Description
The F-Series liquid level sensor features 5-bolt flange mount with fully-integrated electronics. The sensor is manufactured to your custom length requirement and offers a fully configurable 500 -1500Hz Frequency output (typically calibrated 500Hz empty, 1500Hz full) .
Manufactured from aluminum, the sensor utilizes solid-state capacitive technology to accurately detect levels of fuel, oil, bio-fuels and other liquids. The sensor is factory calibrated in your liquid type (or equivalent).
Key Features
- Aluminum Construction
- Available up to 1000mm Long
- Suitable for Use with Fuels, Oils and Bio-Fuels
- 500 Hz – 1500 Hz Frequency output
- -10ºC to +105ºC Operating Temperature
- Factory Calibrated
- Solid-State Capacitive Technology
Electrical Signal Output
| Supply Voltage | +6V DC to +24VDC |
| Supply Current | <10mA @ 12V |
| Output Frequency | 500 Hz – 1500 Hz |
| Range Accuracy | 0.1mm |
Wiring:
| Wire | 0.5mm Teflon wire |
| Wiring Gauge | 18AWG with SS sleeve |
Mechanical & Environmental:
| Probe Length | 100-700mm |
| Mounting | 5 Bolt Round |
| Weight | 150 mg without cables depending on length |
| Operating Temperature | -10 ºC to 105ºC |
| Construction | Aluminum |
| Finish | Anodized Colour |
Installation Procedure:-
1. Connect sensor with frequency input device with wiring shown above.
2. Cut the sensor for desired length if other then 700mm is required.
3. Switch ON power supply; now hold the sensor in dry condition. Wait for frequency other then 15Hz.Switch On/Off the system once again.
4. Sensor will always calibrate from 500 to 1500 Hz scale to reduce software overheads.
